GN3625DX
Description
Design Features:
- The GN3625DX Thermoformer was developed to meet the demand for thermoformed APET products. It was designed to provide greater APET cutting capacity than the standard
- Contact-Heat Cut-In-Place GN3625D Thermoformer
- In-mould cutting ensuring consistent and accurate trim
- Servo driven platen for smooth and energy efficient movement
- Six point toggle systems with oversized roller bearings
- High speed forming system
- Multi-zone contact heating system
- Electric preheater
- Microprocessor-based control systems (PLC)
- Computerized DC drive sheet transport with photo scanning capabilities for pre-printed materials
- Static Eliminator
- Stacking equipment available
GN Tooling:
- Cost effective tooling is designed, manufactured and production tested at our facility
Specifications
| Forming Area | 915mm x 635mm (36" x 25") maximum |
| Depth of Draw | 125mm (5") maximum |
| Material Thickness Range | 0.15mm - 1.00mm (0.006"-0.040") |
| Power Supply | 3x400V+N+PE, 50-60Hz (380-415V) / 3x480V+PE, 50-60Hz (440-480V) / 3x220V+PE, 50-60Hz (220-240V) |
| Cooling Water Consumption | 14 Litres/min @ 15C - 20C (3 gal/min @ 58F - 68F) |
| Machine Dimensions (l x w x h) | 3200mm x 2100mm x 2210mm (126" x 83" x 87") |
| Knife Length | 10500mm (413") for APET / 11430mm (450") for other thermoformable materials |
| Sheet Width | 965mm (38") maximum |
| Material Roll Diameter | 711mm (28") maximum |
| Cycles per Minute | 30 maximum |
| Power Consumption | 12 Kilowatts/hr (Approximate) |
| Air Pressure | 6.8 bar (100 PSI) minimum |
| Air Consumption | 2000 Litres/min (80 CFM) (Approximate) |
| Machine Weight | 5987 kg (13,200 lbs) |
