GN3021DX
Description
Features and Benefits:
- The GN3021DX Thermoformer was developed to meet the demand for thermoformed APET products. It was designed to provide greater APET cutting capacity than the standard
- Contact-Heat Cut-In-Place GN3021C Thermoformer
- In-mould cutting ensuring consistent and accurate trim
- Servo-driven platen for smooth and energy efficient movement
- Four point toggle systems with oversized roller bearings
- High speed forming system
- Multi-zone contact heating system
- Electric pre-heater
- Microprocessor-based control systems (PLC)
- Photo scanning available for preprinted sheet
- Static eliminator
- Stacking equipment available
GN Tooling:
- Cost effective tooling is designed, manufactured and production tested at our facility
Specifications
| Forming Area | 760mm x 530mm (30" x 21") maximum |
| Depth of Draw | 125mm (5") maximum |
| Clamping Force | 100 Ton |
| Sheet Width | 815mm (32") maximum |
| Material Thickness Range | 0.15mm - 1.00mm (0.006"-0.040") |
| Material Roll Diameter | 711mm (28") maximum |
| Dry Cycles per Minute | 30 maximum |
| Main Supply Voltage | 3x400V+N+PE, 50-60Hz (380-415V) / 3x480V+PE, 50-60Hz (440-480V) / 3x220V+PE, 50-60Hz (220-240V) |
| Power Consumption | 7.5 Kilowatts/hr (Approximate) |
| Air Pressure | 6.8 bar (100 PSI) minimum |
| Air Consumption | 1200 Litres/min (42 CFM) (Approximate) |
| Machine Dimensions (l x w x h) | 2895mm x 1850mm x 2160mm (114" x 73" x 85") |
| Knife Length (maximum) | 8500mm (335") for APET / 9525mm (375") for other thermoformable materials |
| Cooling Water Consumption | 6 Litres/min @ 15C - 20C) (1.5 gal/min @ 58F - 68F) |
| Machine Weight | 3420 kg (7540 lbs) |
